Axio Imager 2 INTRODUCTION ZEISS
Warranty information
01/2016 430000-7544-001 13
1.3 Warranty information
The manufacturer guarantees that the instrument is free of material or manufacturing defects upon
delivery. Any defects must be reported immediately and steps taken to minimize damage. If such a defect
is reported, the instrument manufacturer shall be obliged to correct the fault, either by repairing the
instrument or replacing it with a new one, at the manufacturer's discretion. No warranty is given for
defects caused by natural wear and tear (particularly of wearing parts) and improper use of the
instrument.
The instrument manufacturer shall not be liable for damage caused by misuse, negligence or any other
tampering with the instrument, particularly the removal or replacement of instrument components, or
the use of accessories from other manufacturers. Such actions shall invalidate any warranty claims.
With the exception of the work described in this Operating Manual, no maintenance or repair work is to
be carried out on the Axio Imager 2. Repairs may only be performed by ZEISS Service or individuals
specially authorized by ZEISS Service. In the event of a problem with the instrument, please contact your
local ZEISS representative.
1.4 Other operating manuals
In addition to the operating manual for the Axio imager 2, the following operating manuals should also
be consulted:
− Axio Observer Microscope Operating Manual
− ZEN Software Description (blue edition) (online version)
− Operating manual: Installation handbook for peripheral equipment
− Operating manual for the computer system
− Operating manual for the reflected light fluorescence illuminator HBO 100
− Operating manual for HXP 120 V
− Operating manual for the control computer
− Operating manual for the monitor
− Operating manuals for each incubation system
− Operating manual for the SVB 1 signal distribution box
− Operating manual for Auto Focus
− Operating manual for multidiscussion equipment
To Next Page
Loading...
