Axio Imager 2 INTRODUCTION ZEISS
Notes on device safety
01/2016 430000-7544-001 7
1 INTRODUCTION
1.1 Notes on device safety
The Axio Imager 2 microscopes have been designed, produced and tested in compliance with
DIN EN 61010-1 (IEC 61010-1) and IEC 61010-2-101 "Safety requirements for electrical equipment for
measurement, control, and laboratory use".
The devices meet the requirements of the European Directive IVDD 98/79/EC (In Vitro Diagnostic Medical
Devices) and RoHS Directive 2011/65/EC and carry the mark.
The devices are disposed of in accordance with WEEE Directive 2012/19/EC.
This Operating Manual contains information and warnings that must be followed by the owner/operator
personnel.
The following warning and information symbols are used in this Operating Manual:
NOTE
This symbol indicates an instruction which requires particular attention.
ATTENTION
This symbol indicates a potential hazard to the instrument or system.
CAUTION
This symbol indicates a potential hazard to the user.
CAUTION
Hot surface!
CAUTION
Emission of UV radiation!
CAUTION
LED radiation in 400 nm to 700 nm range! LED risk group 1 in accordance with DIN EN
62471:2009
Do not look into the LED light!
CAUTION
Disconnect the instrument from the power supply before opening!
CAUTION
Risk of crushing!
ATTENTION
Stand-
by: Switching the Axio Imager.Z2 and Z2m off using the standby switch only turns off
the internal computer. The mains supply is not switched off.
To Next Page
Loading...
