Axio Imager 2 FIRST-TIME SET-UP ZEISS
Installing and removing P&C reflector modules
01/2016 430000-7544-001 41
3.11 Installing and removing P&C reflector modules
Normally, the reflector turret is factory-equipped with P&C (Push&Click) reflector modules if requested by
the customer. However, the user can also change the equipment of these turrets.
The reflector turret is designed to
hold a maximum of six or ten reflector modules, depending on the
model.
3.11.1 Installing a module
• Fold up cover flap (Fig. 19/4) to the right on
reflector turret (Fig. 19/3) and unhinge it using
the handle (Fig. 19/7) on the left.
• Turn the reflector turret until the desired
position (position ID labeled on reflector turret)
can be accessed in the mounting hole.
• Holding it by the handles (Fig. 19/5) to the right
and left of the module, insert the module
(Fig. 19/6) obliquely from the bottom into the
upper spring clips (Fig. 19/1) on the reflector
turret.
• Then press the bottom of the module until it
snaps securely into the lower spring clips
(Fig. 19/2) of the reflector turret as well.
3.11.2 Removing a module
• Slightly tilting the module, release it first from the bottom spring clips and then from the top spring
clips. Remove it completely.
• After having removed and installed the reflector modules, re-apply the cover flap and let it snap in.
• Turn the reflector turret through three or five positions (10-position reflector turret) to swing the
newly installed module into the optical path.
• After equipping the turret as desired, label the adhesive labels with the new filter combination and
affix them to the corresponding fields on the cover flap.
Fig. 19 Changing P&C reflector modules
To Next Page
Loading...
