Zmorph FAB - Page 61

Product Manual - ZMORPH FAB back to table of content >>
61
Wait till the extruder to heat up. Go to the ‘LOAD/UNLOAD’ menu. Feed the extruder by following

chapter.
3D printing workow
Dual Extruder Toolhead
To preheat the extruder, follow these steps.
Choose the ‘MAINTENANCE’
from the LCD touchscreen
menu.
Choose ‘LOAD FILAMENT’. Choose PARK TOOL, wait
for the machine to position
the toolhead. When done,
choose ‘PLA’ to preheat the
material.
Wait till the extruder reaches
the proper temperature. The
yellow ‘TEMPERATURES’ sign
will change colour from yellow
to green.
Tap the LOAD/UNLOAD menu. Tap the upper LEFT arrow



prevent clogging.
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
LOAD/UNLOAD
PLA
ABS
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
PARK
TOOL
BACK
NEW JOB MAINTENANCE
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
LOAD/UNLOAD
PLA
ABS
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
PARK
TOOL
BACK
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
PARK
TOOL
BACK
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
  