Zmorph FAB - Page 72

Product Manual - ZMORPH FAB back to table of content >>
72
3D printing workow
Choose ‘CALIBRATE’. Choose ‘’. Wait
for the machine to heat up

To ensure the best calibration
result print calibration pattern.
Choose ‘START’.
Set the printing temperature
to the PLA material. Nozzle

To to that tap the gaps and
type the temperature on the
keyboard.
Wait for extruder to heat up.
When done tap ‘NEXT’.
Apply your choice. Zmorph Fab calibration is
complete.
Clean the bed. Your machine

Use the arrow buttons on the
screen to feed the material on
both sides of the extruder until
it start to pour out from the
nozzle. (it might take a couple
times), after that press the
‘NEXT’ button.

printing pattern.
Look at printed lines and
select the best one on the
screen. A correct line is the
one that sticks to the table
after gently touching it with


NONE, REPEAT PRINTING
1 2 3 4 5
NEXT
Choose the best printed line
(numeration from le to right)
LOAD FILAMENT
LEFT RIGHT ALL
NEXTBACK
Calibration complete!
DONE
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
CALIBRATION
AUTO
3-POINT
BACK MORE
MANUAL
CALIBRATION
In the last calibration step the machine
will print five lines as a final touch
SKIP
START
CALIBRATION
NEXTBACK
CURRENTTARGET
NOZZLE
BED
NEXTBACK
TARGET
NOZZLE
BED
CURRENT

 

 
 
 