ZyXEL Communications IES-2000 - Page 105

IES-2000/3000 User’s Guide
SLC1024 Specific Commands 8-3
This command forcibly disables the specified G.SHDSL port.
All SHDSL ports are disabled by default. A port must be enabled before data transmission can
occur. An enabled but disconnected SHDSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port when it is not in
use.
8.5.3 Disable Ports Command
Syntax:
192.168.1.1 gshdsl> disable ports
This command forcibly disables all G.SHDSL ports.
8.5.4 Enable Port Command
Syntax:
192.168.1.1 gshdsl> enable port <port #>
where
<port #> =
A port number, from 1 to 24.
This command forcibly enables the specified G.SHDSL port.
8.5.5 Enable Ports Command
Syntax:
192.168.1.1 gshdsl> enable ports
This command forcibly enables all G.SHDSL ports.
8.5.6 Lineinfo Command
Syntax:
192.168.1.1 gshdsl> lineinfo <port #>
where
<port #> =
A port number, from 1 to 24.
This command shows the line operating values of a G.SHDSL port.
An example is shown next.
192.168.1.1 gshdsl> lineinfo 2
2=Down Sp=0 Tx=0 Tr=0 Rx=0 Rr=0 NM=0 T=000:00:00
where