ZyXEL Communications IES-2000 - Figure 6-1 Example: Procedure to Save and View a Previous Error Log; System Reboot; Errlog Display Command; Errlog Clear Command

IES-2000/3000 User’s Guide
System Commands 6-7
System reboot Out of buffer
6.7.1 Errlog Display Command
Syntax:
192.168.1.1 sys> errlog display
This command displays the system error log.
6.7.2 Errlog Clear Command
Syntax:
192.168.1.1 sys> errlog clear
This command clears the system error log.
If you clear a log (using the errlog clear command), you may not view it again.
6.7.3 Saving and Viewing a Previous Error Log
You may save and view a previous error log after warm restarting the line card (refer to Figure 6-1).
Figure 6-1 Example: Procedure to Save and View a Previous Error Log
6.7.4 Get Slot Command
Syntax:
192.168.1.1 sys> get slot
This command displays the slot number for this line card in the chassis. This is an optional parameter to help
keep track of individual line cards.
192.168.1.1> sys
192.168.1.1 sys> errlog display
0 Thu Jan 01 00:00:12 SNMPR WARN Cold Start Trap
1 Thu Jan 01 00:00:14 CONSOL INFO CONSOLE Session Begin
192.168.1.1 sys> home
192.168.1.1> restart
192.168.1.1> fm
192.168.1.1 fm> cat errorlog
0 Thu Jan 01 00:00:12 SNMPR WARN Cold Start Trap
1 Thu Jan 01 00:00:14 CONSOL INFO CONSOLE Session Begin
Log in memory before you restart
your IES-2000/3000.
Make sure you restart using these CI
commands. This procedure will not
work if you cold restart the IES-
2000/3000. DO NOT turn the IES-
2000/3000 power switch off and on
during this procedure.
Log in file after you restart your IES-
2000/3000.