ZyXEL Communications IES-2000 - Default Settings

IES-2000/3000 User’s Guide
7-2 ALC1024 Specific Commands
multiple of 32Kbps. For instance, if you specify 60 Kbps for a port, the actual rate for that port will not exceed 32
Kbps, and if you specify 66 Kbps, the actual rate will not be over 64Kbps.
Note that when you configure an ADSL port, the upstream rate must be less than or equal to the downstream rate.
Note also that the
list port command displays the configured parameters of the ADSL port, while the show
port
command displays the actual rates.
7.4 Default Settings
The default profile always exists and all of the ADSL ports use the default profile settings when the ALC1024 is
shipped. The default profile's name is set to
DEFVAL. The default profile’s maximum downstream rate can only be
obtained when using the G.dmt standard. Configure a profile with a maximum downstream rate of 1536 Kbps or
less for use with G.lite.
7.4.1 Default Profile Settings
The following are the settings of the default profile.
- Name: DEFVAL
- Profile Status: Active
Downstream ADSL settings:
- Target Signal/Noise Ratio: 6 db
- Maximum Signal/Noise Ratio: 31 db
- Minimum Signal/Noise Ratio: 0 db
- Minimum Transmission Rate: 32 Kbps
- Maximum Transmission Rate: 2048 Kbps
Upstream ADSL settings:
- Target Signal/Noise Ratio: 6 db
- Maximum Signal/Noise Ratio: 31 db
- Minimum Signal/Noise Ratio: 0 db
- Minimum Transmission Rate: 32 Kbps
- Maximum Transmission Rate: 512 Kbps
7.4.2 Other Default Settings
The factory default settings for all ADSL ports of the ALC1024 are
- Encapsulation: RFC 1483
- Multiplexing: LLC-based