ZyXEL Communications IES-2000 - Figure 27-10 Ethernet Flow Control; Figure 27-11 Ethernet Monitor Status; Figure 27-12 Enet Monitor Statistics

IES-2000/3000 User’s Guide
27-12 VDSL-Related Commands
Table 27-7 Ethernet Speed Parameters
SPEED INDEX NUMBER SPEED/FLOW CONTROL
0
Auto Negotiation
1
10 Mbits/s, Half Duplex
2
10 Mbits/s, Full Duplex
3
100Mbits/s, Half Duplex
4
100Mbits/s, Full Duplex
27.3.4 Enet Fctrl Command
Syntax:
vdsl enet fctrl chan-id (lt|nt) [on|off]
Type this command to set the Ethernet port flow control. By default, flow control is on for full duplex Ethernet
connections and off for half duplex Ethernet connections.
Figure 27-10 Ethernet Flow Control
27.3.5 Enet Monitor Command
vdsl enet monitor chan-id [on|off]
When this flag is on, this command automatically displays the VLC1012 Ethernet statistics every five seconds
(and those of the subscriber’s VDSL modem if the link is up).
Figure 27-11 Ethernet Monitor Status
Figure 27-12 Enet Monitor Statistics
vlc1012> vdsl enet monitor vdsl02
enet monitor flag: off
vlc1012> vdsl enet fctrl vdsl02
enet flow control(LT): on
>vdsl enet mon vdsl02 on
vlc1012> 108:Enet(LT):Tx(F:0 B:0 S:0) Rx(F:681 B:85833 S:1950)
109:Enet(NT):Tx(F:694 B:90140 S:2709) Rx(F:0 B:0 S:0)
113:Enet(LT):Tx(F:0 B:0 S:0) Rx(F:815 B:117449 S:6323)
114:Enet(NT):Tx(F:828 B:119529 S:5877) Rx(F:0 B:0 S:0)
118:Enet(LT):Tx(F:0 B:0 S:0) Rx(F:876 B:125667 S:1643)
119:Enet(NT):Tx(F:884 B:126557 S:1405) Rx(F:0 B:0 S:0)
123:Enet(LT):Tx(F:0 B:0 S:0) Rx(F:934 B:134174 S:1701)
124:Enet(NT):Tx(F:943 B:134941 S:1676) Rx(F:0 B:0 S:0)
128:Enet(LT):Tx(F:0 B:0 S:0) Rx(F:980 B:138422 S:849)
vlc1012> vdsl enet mon off
129:Enet(NT):Tx(F:989 B:139256 S:863) Rx(F:0 B:0 S:0)