ZyXEL Communications IES-2000 - Table 27-4 VDSL Rates

IES-2000/3000 User’s Guide
27-4 VDSL-Related Commands
Downstream
Syntax:
vdsl downrate chan-id [downrate]
downrate
is an integer from 0 to 4 defined in the next table. This command sets the upstream VDSL rate. After
you set the rate, you must use
vdsl reset chan-id or vdsl recon chan-id to make VDSL reconnect.
Table 27-4 VDSL Rates
UPRATE/DOWN
RATE
UPSTREAM RATE DOWNSTREAM RATE
10Base-S
0 1.56Mbps 4.17Mbps
1 6.25Mbps 6.25Mbps
2 9.38Mbps 8.33Mbps
3 12.50Mbps 12.50Mbps
4 18.75Mbps 16.67Mbps
ANSI / ETSI Plan 998
0 1.56Mbps 4.17Mbps
1 3.13Mbps 6.25Mbps
2 6.25Mbps 8.33Mbps
3 12.50Mbps
4 16.67Mbps
ETSI Plan 997
0 1.56Mbps 4.17Mbps
1 3.13Mbps 6.25Mbps
2 6.25Mbps 9.38Mbps
3 12.50Mbps
27.2.4 Reset a VDSL Channel
Syntax:
vdsl reset chan-id [lt|nt]
This command issues a software-reset command to the VDSL chip. lt is local or the VLC1012 VDSL chip; nt is
the remote VDSL modem chip. The VDSL link first disconnects before the channel resets.