IES-2000/3000 User’s Guide
VDSL-Related Commands 27-1
Chapter 27
VDSL-Related
Commands
This chapter shows you how to configure VDSL using line interface commands.
27.1 Introduction
CI commands contain advanced configuration features that may be used for debugging and troubleshooting.
Exercise caution when using CI commands as incorrect usage may damage your VLC1012.
27.1.1 VDSL Default Values
The default values for the following VDSL parameters are shown in the next table.
Table 27-1 VDSL Default Values
VDSL PARAMETER DEFAULT VALUE
VDSL Mode 0 = 10BaseS mode
VDSL Active On
VDSL Upstream Rate 12.5 Mbps
VDSL Downstream Rate 12.5 Mbps
Enter 8 from menu 24 to go to CI command mode.
Figure 27-1 CI Command Mode
Type “?” to see the first level of commands.
Menu 24 — System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
11. Remote Management Control
12. Hardware Monitor
Enter Menu Selection Number:
To Next Page
Loading...
