ZyXEL Communications IES-2000 - Default Settings; G.SHDSL Commands

IES-2000/3000 User’s Guide
8-2 SLC1024 Specific Commands
8.4 Default Settings
The default profile always exists and all of the G.SHDSL ports use the default profile settings when the SLC1024
is shipped. The default profile's name is set to DEFVAL.
8.4.1 Default Profile Settings
The following are the settings of the default profile.
• Name: DEFVAL
• Minimum Transmission Rate: 192 Kbps
• Maximum Transmission Rate: 2304 Kbps
8.5 G.SHDSL Commands
The commands related to one subsystem are grouped under a primary command of that subsystem, for instance, to
configure the G.SHDSL parameters, you must first enter the G.SHDSL subsystem by entering the gshdsl
command as shown next.
Syntax:
192.168.1.1> gshdsl
192.168.1.1 gshdsl>
When you see the 192.168.1.1 gshdsl> command line prompt, you are ready to enter G.SHDSL
commands. Enter the
home command to return to the “192.168.1.1>” prompt.
8.5.1 Config Save Command
Syntax:
192.168.1.1 gshdsl> config save
This command saves the G.SHDSL configuration into nonvolatile memory. You must use this command to save
any configurations that you make, otherwise the SLC1024 will return to its default settings when it is restarted.
Do not turn off your IES-2000/3000 while saving your configuration.
8.5.2 Disable Port Command
Syntax:
192.168.1.1 gshdsl> disable port <port #>
where
<port #> =
A port number, from 1 to 24.