IES-2000/3000 User’s Guide
27-10 VDSL-Related Commands
Refer to Table 27-5 for more information on these fields.
27.2.14 VDSL Autoupg Command
Syntax:
vdsl autoupg chan-id [on|off]
Type this command to turn on/off auto upgrade. When auto upgrade is on, the VLC1012 will check the
subscriber’s modem VDSL modem code version and automatically upgrade it if it is an earlier version than the
VLC1012’s.
27.3 VDSL-Ethernet-related Commands
27.3.1 View Ethernet Status Counters
Syntax:
vdsl enet status chan-id
This command displays the current Ethernet counters of the VLC1012 and VDSL modem.
Figure 27-9 Ethernet Status Counters
The following table explains these parameters.
Table 27-6 Ethernet Status Counters
COUNTER MEANING
ALGM_ERR
This is the number of frames received with alignment errors (odd number of nibbles).
SINGLE_COL
A count of successfully transmitted frames for which transmission is inhibited by exactly one
collision.
MUL_COL
A count of successfully transmitted frames for which transmission was inhibited by more than
one collision.
vlc1012> vdsl enet st vdsl01
VDSL Channel vdsl01:
LT Ethernet Counters:
ALGM_ERR = 0 SINGLE_COL = 0 MUL_COL = 0
LATE_COL = 0 EXC_COL = 0 MACRX_ERR = 0 CS_ERR = 0
FTL_ERR = 0 FCS_ERR = 0 OTO = 13641294 ORO = 0
BCF = 0 RXPAUS = 0 TXPAUS = 0 TXBCNT = 75120
RXBCNT = 0 TX_DEF = 0
NT PHY: LSI 80225
NT Ethernet speed: 100M Full Duplex
NT Ethernet Counters:
ALGM_ERR = 0 SINGLE_COL = 0 MUL_COL = 0
LATE_COL = 0 EXC_COL = 0 MACRX_ERR = 1 CS_ERR = 0
FTL_ERR = 0 FCS_ERR = 0 OTO = 0 ORO = 13642095
BCF = 67493 RXPAUS = 0 TXPAUS = 0 TXBCNT = 0
RXBCNT = 75138 TX_DEF = 0
vlc1012>
To Next Page
Loading...
