IES-2000/3000 User’s Guide
Bridge Commands 10-7
- Bridge port 25 (DSL port 24) allowed to bridge port 1 (Ethernet uplink port) only
The default VLAN settings allow each DSL port to communicate back and forth with only the Ethernet uplink
port, and not with other DSL ports. The following figure illustrates this.
Figure 10-1 Default VLAN Settings
10.6.1 Portfilter Command
Syntax:
192.168.1.1 bridge> portfilter [<source port> all|<dest ports>]
where
<source port> =
An incoming bridge port number.
all =
All bridge ports are allowed outgoing ports.
<dest ports> =
The outgoing bridge ports. Separate by a space if there is more than one port.
This command sets or displays the port-based VLAN configuration.
An example is shown next.
192.168.1.1 > bridge
192.168.1.1 bridge> portfilter
Port 1 (ethernet): all
Port 2 (dsl1): 1
Port 3 (dsl2): 1
Port 4 (dsl3): 1
Port 5 (dsl4): 1
Port 6 (dsl5): 1
Port 7 (dsl6): 1
Port 8 (dsl7): 1
Port 9 (dsl8): 1
Port 10 (dsl9): 1
Port 11 (dsl10): 1
To Next Page
Loading...
