ZyXEL Communications IES-2000 - VDSL Commands; Figure 27-2 CI Commands; Table 27-2 VDSL-Related Commands

IES-2000/3000 User’s Guide
27-2 VDSL-Related Commands
Figure 27-2 CI Commands
27.2 VDSL Commands
The following table is a summary of VDSL-related commands.
Table 27-2 VDSL-related Commands
COMMAND DESCRIPTION
vdsl uprate chan-id (x)
This command sets the VDSL upstream rate (0 to 4)
vdsl downrate chan-id (y)
This command sets the VDSL downstream rate (0 to 4)
vdsl patch chan-id [lt|nt]
This command loads new VDSL modem code into the VLC1012 (nt)
or VDSL subscriber modem (lt).
vdsl reset chan-id [lt|nt]
This command resets the VDSL chip.
vdsl reconnect chan-id
Make VDSL reconnect
vdsl clear chan-id
Clear VDSL related counters
vdsl debug chan-id [on|off]
This command sets the VDSL debug flag.
vdsl monitor chan-id [on|off]
This command sets the VDSL monitor flag.
vdsl status chan-id
This command shows the VDSL status counters.
vdsl show chan-id
This command shows VDSL settings.
vdsl mode chan-id (mode)
This command changes the VDSL mode (0 = 10BaseS, 1 = ANSI, 2
= ETSI).
vdsl active chan-id [on|off]
This command actives/deactivates the VDSL driver.
vdsl autoupg chan-id [on|off]
This command enables/disables NT modem F/W auto upgrade.
vdsl ver
This command shows the VDSL driver version.
vdsl quality chan-id
This command shows VDSL quality.
vdsl enet status chan-id
This command shows Ethernet status counters.
vdsl enet clear chan-id
This command clears Ethernet status counters.
vdsl enet monitor chan-id [on|off]
This command sets the VDSL chip Ethernet monitor flag
vdsl enet phy chan-id
This command shows the NT Ethernet PHY registers.
chan-id (vdsl01, vdsl02,…vdsl12) refers to the channel name for each VDSL channel. all is also a valid
channel name that indicates all channels.
All VDSL parameters and flags set using VDSL commands are effective at run-time only. If you
restart the VLC1012, you will lose the configuration changes you made with commands. To save
changes permanently, please use the appropriate SMT menu.
vlc1012> ?
Valid commands are:
sys exit device ether
vdsl bridge sw monitor
vlc1012>