IES-2000/3000 User’s Guide
26-6 System Maintenance 2
Figure 26-6 Menu 24.12 - Hardware Monitor
Table 26-5 Menu 24.12 - Hardware Monitor
FIELD DESCRIPTION EXAMPLE
Temperature (C) There are three temperature sensors inside the VLC1012. Each sensor is
capable of detecting and reporting if the temperature rises above the
threshold. Temp 1 refers to the first temperature sensor and has a threshold
of 75 degrees centigrade, the second and third temperature sensors have
thresholds of 65 degrees centigrade.
Temp1
Current This shows the current temperature in degrees centigrade at this sensor. 35.0
Max This field displays the maximum temperature measured at this sensor. 37.0
Min This field displays the minimum temperature measured at this sensor. 34.0
Threshold This field displays the upper temperature limit at this sensor. 65.0
Status This field displays “Normal” for temperatures below the threshold. Normal
Voltage (V) The power supply for each voltage has a sensor that is capable of detecting
and reporting if the voltage falls out of the tolerance range.
V2.0
Current This is the current voltage reading. 2.03
Max This field displays the maximum voltage measured at this point.
Min This field displays the minimum voltage measured at this point.
Tolerance (%) Ten percent is the acceptable deviation a voltage of 2.0. Five percent is the
acceptable deviation from the other nominal voltages.
5%
Status “Normal” indicates that the voltage is within an acceptable operating range at
this point.
Normal
COMMANDS:
Menu 24.12 — Hardware Monitor
Temperature(C) Current Max Min Threshold Status
TEMP1 35.0 37.0 34.0 75.0 Normal
TEMP2 32.5 35.5 30.0 65.0 Normal
TEMP3 43.0 46.0 40.5 65.0 Normal
Voltage(V) Current Max Min Tolerance(%) Status
2.0 2.06 2.11 2.02 10 Normal
2.5 2.61 2.62 2.58 5 Normal
3.3 3.31 3.36 3.30 5 Normal
5.0 5.06 5.15 4.99 5 Normal
15.0 14.53 15.02 14.35 5 Normal
-5.0 -5.15 -5.15 -5.25 5 Normal
Press Command:
COMMANDS:r-Reset status ESC-exit
To Next Page
Loading...
