IES-2000/3000 User’s Guide
System Maintenance 2 26-5
Table 26-4 Menu 24.11.1.1 - Secured Client Configuration
FIELD DESCRIPTION EXAMPLE
Secured IP
addr_start To allow a range of computers to use Telnet, FTP or ICMP services then enter
the first IP address in the range here.
The default value for a start and end address is 0.0.0.0, which means you don’t
care which host is trying to use a service (Telnet, FTP, or ICMP).
If you enter an IP address in this field, the VLC1012 will check if the client IP
address matches the value here when a (Telnet, FTP, or ICMP) session is up. If
it does not match, the VLC1012 will disconnect the session immediately. If the
service field is disabled in menu 24.11, then this field and the next field are N/A.
0.0.0.0
addr_end To allow a range of computers to use Telnet, FTP or ICMP services, enter the
end IP address in the range here. To allow a single computer to use Telnet, FTP
or ICMP services, enter the same IP address here as in the previous field.
0.0.0.0
Service Type
TELNET
Service
Press [SPACE BAR] to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
FTP Service Press [SPACE BAR] to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
Web Service Press [SPACE BAR] to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
ICMP Service Press [SPACE BAR] once to select Yes or No and then press [ENTER] to
activate/deactivate this service for the trusted computers specified above.
Yes
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to Cancel" to
save your configuration, or press [ESC] to cancel.
26.4 Hardware Monitor
Enter 12 from Menu 24 – System Maintenance to go to the next menu shown.
To Next Page
Loading...
