ZyXEL Communications IES-2000 - Chapter 22 VLAN Setup; Introduction; VLAN Setup Configuration; Figure 22-1 Main Setup Menu

IES-2000/3000 User’s Guide
VLAN Setup 22-1
Chapter 22
VLAN
Setup
This chapter shows you how to set up VLAN on the switch using SMT menu 17.
22.1 Introduction
To activate IEEE 802.1Q on the VLC1012, you must enable it for the switch in menu 2, the port in menu 6 port
submenu(s) and menu 17 VLAN setup. Menu 17 allows you to enable GVRP on the switch and configure static
VLANs. See elsewhere in this manual for VLAN configuration using menus 2 and 6.
Figure 22-1 Main Setup Menu
22.2 VLAN Setup Configuration
Step 1. Select 802.1Q as the VLAN Type in Menu 2 — Switch Setup.
Step 2. Enter 17 from the main menu to go to Menu 17 — VLAN Setup.
This menu is not available (Menu 17 – VLAN Setup (N/A)) if you have not selected 802.1Q as the
VLAN type in Menu 2 – Switch Setup.
Figure 22-2 Menu 17 VLAN Setup
Copyright (c) 1994 - 2002 ZyXEL Communications Corp.
VLC-1012 Main Menu ()
Getting Started Advanced Management
1. General Setup
2. Switch Setup 22. SNMP Configuration
3. IP Setup 23. System Password
24. System Maintenance
6. Port Setup
Advanced Applications
12. Static Routing Setup
17. VLAN Setup 99. Exit
Enter Menu Selection Number:
Menu 17 - VLAN Setup
GVRP= Disable
Management VLAN ID= 1
Edit 802.1Q VLAN Static Entry= No
Press ENTER to Confirm or ESC to Cancel: