IES-2000/3000 User’s Guide
System Maintenance 1 24-11
Figure 24-12 Menu 24.3.2 – System Maintenance – UNIX Syslog
Configure the UNIX syslog parameters described in the following table to activate syslog.
Table 24-6 System Maintenance Menu Syslog Parameters
FIELD DESCRIPTION
Syslog:
Active Press [SPACE BAR] to turn on or off syslog.
Syslog IP Address Enter the IP address of the syslog server .
Log Facility Press [SPACE BAR] to toggle between the 7 different Local options. The log facility allows
you to log the message to different files in the server. Please refer to your UNIX manual for
more details.
Types:
CDR Connection Detail Record (CDR) logs all VDSL connection activity if set to Yes.
Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to Confirm” to save
your configuration, or press [ESC] to cancel.
24.5 Diagnostic
The diagnostic facility allows you to test the different aspects of your VLC1012 to determine if it is working
properly. Menu 24.4 allows you to choose among various types of diagnostic tests to evaluate your system, as
shown next.
Figure 24-13 Menu 24.4 – System Maintenance – Diagnostic
Menu 24.4 — System Maintenance — Diagnostic
TCP/IP Port
1. Ping Host 21. Reset Port
22. Local Loopback Test
23. Remote Loopback Test
System
11. Reboot System VDSL
31. Update Remote Firmware
32. Reconnect
Enter Menu Selection Number:
Host IP Address= N/A
Port Number=
Menu 24.3.2 -- System Maintenance — UNIX Syslog
Syslog:
Active= No
Syslog IP Address= ?
Log Facility= Local 1
Types:
CDR= No
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
To Next Page
Loading...
