IES-2000/3000 User’s Guide
System Maintenance 2 26-1
Chapter 26
System
Maintenance 2
This chapter discusses CI Mode, Remote Management Control and Hardware Monitor SMT menus.
26.1 Command Interpreter Mode
This option allows you to enter command interpreter mode, which allows more advanced system diagnosis and
troubleshooting. Enter 8 from Menu 24 – System Maintenance. A list of valid commands can be found by typing
“help” or “?” at the command prompt. Enter “exit” to return to the SMT main menu when finished.
Figure 26-1 Valid CI Commands
See the later chapters for more detailed information on CI commands.
26.2 Time and Date Setting
Menu 24.10 - Time and Date Setting allows you to set the time manually or get the current time and date from an
external server when you turn on your VLC1012. The real time is then displayed in the VLC1012 logs.
Select menu 24 in the main menu to open Menu 24 - System Maintenance and then enter 10 to go to Menu 24.10
— System Maintenance — Time and Date Setting to update the time and date settings of your VLC1012 as
shown in the following screen.
vlc1012> ?
Valid commands are:
sys exit device ether
vdsl bridge sw monitor
vlc1012>
To Next Page
Loading...
