ZyXEL Communications IES-2000 - Enable Command

IES-2000/3000 User’s Guide
IP Commands 13-5
192.168.1.1 ip> route delete <dom name>
where
<dom name> =
The name of the static route.
This command removes a static, IP forwarding route.
13.2.10 Route Flush Command
Syntax:
192.168.1.1 ip> route flush
This command removes all of the static IP forwarding routes.
13.2.11 Enable Command
Your telnet session disconnects when you change the Ethernet port’s IP address. Initiate a
telnet session to the new IP address in order to reconnect.
Syntax:
192.168.1.1 ip> enable [<i/f> [mtu <size>] [<IPaddr>]]
where
<i/f> =
The name of an interface (“ether” for this device).
[mtu <size>] =
Maximum Transmit Unit. The maximum packet size that this interface is to
send.
<IPaddr> =
The IP address of the device’s interface.
This command sets the Ethernet port’s IP address and the largest packet size that this interface sends.