ZyXEL Communications IES-2000 - Figure 11-6 Example: DVLAN List Command Display; Figure 11-7 Example: DVLAN Getentry 2 Command Display

IES-2000/3000 User’s Guide
IEEE 802.1Q Tagged VLAN Commands 11-11
Figure 11-6 Example: DVLAN List Command Display
In the figure above, “||” denotes “filter” and “>>” denotes “forward”.
11.6.11 DVLAN Getentry Command
Syntax:
192.168.1.1 vlan1q> dvlan getentry <vid>
where
<vid> =
VLAN ID. Valid parameter range = [1 – 4094].
This command displays an entry with a specified VLAN ID in dynamic GVRP table.
Display a Dynamic VLAN Table Entry Example
The following figure is an example display of the following command.
192.168.1.1 vlan1q> dvlan getentry 2
Figure 11-7 Example: DVLAN Getentry 2 Command Display
In the figure above, “||” denotes “filter” and “>>” denotes “forward”.
11.6.12 VLAN List Command
Syntax:
192.168.1.1 vlan1q> vlan list
This command displays the entire VLAN table. The display refreshes periodically. Press [ENTER] and then
enter the stop command to stop the display from refreshing. The following figure is a partial example what is
displayed when you use this command (there would be 25 port numbers with a 24 port DSL card).
vid 01 02 03 04 05 06 07 08 09
---- ---- ---- ---- ---- ---- ---- ---- ---- ----
2
||
>>
||
||
>
>
>
>
||
||
>
>
vid 01 02 03 04 05 06 07 08 09
---- ---- ---- ---- ---- ---- ---- ---- ---- ----
2 || >> || || >> >> || || >>
3 >> >> || || || >> >> >> ||
4 >> || || >> >> || || >> >>
5 || >> || || >> >> || || >>
6 >> >> || || || >> >> >> ||
7 || >> || >> >> || || >> >>
8 >> || || >> || >> >> >> >>
9 || >> || || || >> || >> >>