ZyXEL Communications IES-2000 - Figure 11-5 Example: Svlan Getentry 2 Command Display

IES-2000/3000 User’s Guide
11-10 IEEE 802.1QTagged VLAN Commands
11.6.8 SVLAN Getentry Command
Syntax:
192.168.1.1 vlan1q> svlan getentry <vid>
where
<vid> =
VLAN ID. Valid parameter range = [1 – 4094].
This command displays an entry with a specified VLAN ID in the static VLAN table.
Display a Static VLAN Table Entry Example
The following figure is an example display of the following command.
192.168.1.1 vlan1q> svlan getentry 2
Figure 11-5 Example: Svlan Getentry 2 Command Display
11.6.9 SVLAN Delentry Command
Syntax:
192.168.1.1 vlan1q> svlan delentry <vid>
where
<vid> =
VLAN ID. Valid parameter range = [1 – 4094].
This command deletes an entry with a specified VLAN ID in the static VLAN table
Delete a Static VLAN Entry Example
The following example will delete entry 2 in the static VLAN table.
192.168.1.1 vlan1q> svlan delentry 2
11.6.10 DVLAN List Command
Syntax:
192.168.1.1 vlan1q> dvlan list
This command displays the dynamic VLAN registration table. The following figure is a partial example of
what is displayed when you use this command (there would be 25 port numbers with a 24 port DSL card).
vid port# ad_control tag_control
-------- ------- ------------ ------------
2 1 normal UnTag
2 fixed UnTag
3 normal UnTag