ZyXEL Communications IES-2000 - Secured Host Commands; Set Contact Command; Set Mode Command

IES-2000/3000 User’s Guide
6-4 System Commands
This command allows you to set the name of your line card. The previous setting will be cleared if the command
is entered with the <name> parameter omitted.
6.4.3 Set Contact Command
Syntax:
192.168.1.1 sys> set contact [<name>]
This command allows you to set the name of the contact person for your line card. The previous setting will be
cleared if the command is entered with the name omitted.
6.4.4 Set Location Command
Syntax:
192.168.1.1 sys> set location [<name>]
This command allows you to set the location of your line card. The previous setting will be cleared if the
command is entered with the location omitted.
6.4.5 Set Mode Command
Syntax:
192.168.1.1 sys> set mode [fast/normal]
where
fast =
Makes use of the “tag” subset of the IEEE 802.1Q standard to identify the source port
of a frame and speed traffic through a service gateway.
normal =
Switches frames using a layer two switch (IEEE 801.1D) transparent bridge standard.
Use normal mode when you are using a regular gateway.
This command lets you set the line card into fast or normal mode. Determine which mode you are using by
entering the info command.
Enable fast mode only when you are using a service gateway.
6.5 Secured Host Commands
Allow up to ten remote computers to access your line card via IP addresses you specify.
6.5.1 Secured Host Command
Syntax:
192.168.1.1 sys> secured host [<mode>]
where