ZyXEL Communications IES-2000 - IEEE 802.1 Q Tagged VLAN Commands

IES-2000/3000 User’s Guide
IEEE 802.1Q Tagged VLAN Commands 11-3
7.
192.168.1.1 vlan1q> pvid 3 12
8.
192.168.1.1 vlan1q> svlan setentry 13 4 fixed untag
9.
192.168.1.1 vlan1q> svlan setentry 13 1 fixed tag
10.
192.168.1.1 vlan1q> pvid 4 13
11.
192.168.1.1 vlan1q> svlan setentry 14 5 fixed untag
12.
192.168.1.1 vlan1q> svlan setentry 14 1 fixed tag
13.
192.168.1.1 vlan1q> pvid 5 14
14.
192.168.1.1 vlan1q> svlan setentry 15 6 fixed untag
15.
192.168.1.1 vlan1q> svlan setentry 15 1 fixed tag
16.
192.168.1.1 vlan1q> pvid 6 15
………………..
17.
192.168.1.1 vlan1q> svlan setentry 34 25 fixed untag
18.
192.168.1.1 vlan1q> svlan setentry 34 1 fixed untag
19.
192.168.1.1 vlan1q> pvid 25 34
Step 2.
Configure your management VLAN.
• Use the
svlan setentry command to configure a VLAN ID for your device (the “management” or
“CPU” VLAN.
• Use the
svlan cpu command to register your device as a member of the management VLAN.
Example:
1.
192.168.1.1 vlan1q> svlan setentry 2 1 fixed tag
2.
192.168.1.1 vlan1q> svlan cpu 2
Step 3.
Perform the procedure below to complete the VLAN setup after you have configured all the line cards
in the chassis. Note that this must be the last step before you lose the connection to the line card.
• Telnet to the operational IP address of a line card.
• Use the
svlan delentry command to remove the default VLAN ID (1).
• Use the
vlan enable command to activate the VLAN after you have finished all of your
configuration.
Example:
1.
192.168.1.1 vlan1q> svlan delentry 1
2.
192.168.1.1 vlan1q> vlan enable
11.6 IEEE 802.1Q Tagged VLAN Commands
Bridge port 1 stands for the Ethernet uplink port, bridge port 2 stands for DSL port 1, bridge port
3 stands for DSL port 2, and so on.