ZyXEL Communications IES-2000 - Page 130

IES-2000/3000 User’s Guide
11-4 IEEE 802.1QTagged VLAN Commands
11.6.1 Enabling the IEEE 802.1Q Tagged VLAN
The IEEE 802.1Q Tagged VLAN is disabled by default. Enable the IEEE 802.1Q Tagged VLAN by following the
example shown next.
Syntax:
192.168.1.1 vlan1q> vlan enable
11.6.2 Disabling the IEEE 802.1Q Tagged VLAN
You can disable the IEEE 802.1Q Tagged VLAN by using the VLAN Disable command.
Syntax:
192.168.1.1 vlan1q> vlan disable
11.6.3 VLAN Status Command
Syntax:
192.168.1.1 vlan1q> vlan status
This command displays the current configuration of the IEEE 802.1Q bridge. See the following example.
192.168.1.1 vlan1q> vlan status
IEEE 802.1Q VLAN : DISABLED
VLAN Egress Ports Untagged Ports
ID C E 12345678 12345678 12345678 C E 12345678 12345678 12345678
================================================================================
1 - v vvvvvvvv vvvvvvvv vvvvvvvv v v vvvvvvvv vvvvvvvv vvvvvvvv
Total 1 VLAN(s).
The default port VLAN id of all bridge ports:
Port 0 (CPU): 1
Port 1 (ethernet): 1
Port 2 (adsl1): 1
Port 3 (adsl2): 1
Port 4 (adsl3): 1