ZyXEL Communications IES-2000 - Page 131

IES-2000/3000 User’s Guide
IEEE 802.1Q Tagged VLAN Commands 11-5
Port 5 (adsl4): 1
Port 6 (adsl5): 1
Port 7 (adsl6): 1
Port 8 (adsl7): 1
Port 9 (adsl8): 1
Port 10 (adsl9): 1
Port 11 (adsl10): 1
Port 12 (adsl11): 1
Port 13 (adsl12): 1
Port 14 (adsl13): 1
Port 15 (adsl14): 1
Port 16 (adsl15): 1
Port 17 (adsl16): 1
Port 18 (adsl17): 1
Port 19 (adsl18): 1
Port 20 (adsl19): 1
Port 21 (adsl20): 1
Port 22 (adsl21): 1
Port 23 (adsl22): 1
Port 24 (adsl23): 1
Port 25 (adsl24): 1
172.21.100.113 vlan1q>
These are the default VLAN settings. The default VLAN allows all ports to connect to each other and sets them to
send untagged packets.
11.6.4 PVID Command
Syntax:
192.168.1.1 vlan1q> pvid [<port #> <vlan id>]
where
<port #> =
Bridge port number. Valid parameter range = [1 - 25].
<vlan id> =
VLAN ID. Valid parameter range = [1 - 4094].
This command sets the VLAN ID to a specific port in the PVID table. To display the PVID table simply enter
this command without parameters, as shown next.