ZyXEL Communications IES-2000 - MAC Filter Commands; Device Command

IES-2000/3000 User’s Guide
10-2 Bridge Commands
10.3.1 Config Save Command
Syntax:
192.168.1.1 bridge> config save
This command saves the bridge configuration into nonvolatile memory. You must use this command to save
any configurations that you make, otherwise the line card will return to its default settings when it is restarted.
Do not turn off your IES-2000/3000 while saving your configuration.
10.3.2 Device Command
Syntax:
192.168.1.1 bridge> device
This command shows information on all bridge ports.
10.3.3 Status Command
Syntax:
192.168.1.1 bridge> status
This command displays the bridge status.
10.4 MAC Filter Commands
Use MAC filter commands to filter incoming frames based on MAC (Media Access Control) address(es) that you
specify. If you do not use this command, your line card will not filter frames. MAC filter commands are listed
next. You may specify up to five MAC addresses per port.
10.4.1 MAC Filter Command
Syntax:
192.168.1.1 bridge> macfilter [<port>]
where
<port> =
A bridge port number.
This command displays the MAC filtering status and the fixed source MAC addresses on a port or on all ports
if no port number is specified.