ZyXEL Communications IES-2000 - Figure 16-3 Database Edit Dialog; Figure 16-4 Enable BOOTP;TFTP; Figure 16-5 Enter Debug Mode

IES-2000/3000 User’s Guide
16-4 Firmware Upload and Recovery
Figure 16-3 Database Edit Dialog
5. Select Normal Bootp to enable normal BOOTP/TFTP functions.
Figure 16-4 Enable BOOTP/TFTP
6. Restart the line card and press any key within three seconds to get the following screen.
Figure 16-5 Enter Debug Mode
7.
Press any key at the “Press any key within 3 seconds to enter debug mode
………………” message, to enter the debug mode.
SDRAM Testing ...
Mac address 00:A0:C5:12:34:56