ZyXEL Communications IES-2000 - Show Ports Command

IES-2000/3000 User’s Guide
ALC1024 Specific Commands 7-13
The show port command shows the line status (up or down), the actual upstream/downstream rates and mode of
an individual ADSL port.
7.5.20 Show Ports Command
Syntax:
192.168.1.1 adsl> show ports
The show ports command shows the line status (up or down), the actual upstream/downstream rates and the
mode of all ADSL ports.
7.5.21 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc <port number> <multiplexing mode> <tx vpi> <tx vci>
[<rx vpi> <rx vci>]
where
<port number>
= A port number, from 1 to 24.
<multiplexing mode>
= Either llc or vc.
<tx vpi> = The VPI setting of the ADSL port for use with a TX based network.
<tx vci> = The VCI setting for the ADSL port for use with a TX based network.
<rx vpi> = The VPI setting for the ADSL port for use with Rx based networks.
<rx vci> = The VCI setting for the ADSL port for use with Rx based networks.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual ADSL
port.
The
<rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the
rx .settings are not configured.
7.5.22 Set PVCs Command
Syntax:
192.168.1.1 adsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx vpi> <rx
vci>]
where
<multiplexing mode>
= either “llc” or “vc”
<tx vpi>
= The VPI setting of the ADSL port for use with a TX based network.
<tx vci> = The VCI setting for the ADSL port for use with a TX based network.