IES-2000/3000 User’s Guide
7-12 ALC1024 Specific Commands
The set port command assigns an individual port to a specific profile and sets the port’s mode, or standard. The
profile defines the maximum and minimum upstream/downstream rates, the target upstream/downstream signal
noise margins, and the maximum and minimum upstream/downstream acceptable noise margins of all the ADSL
ports that are assigned to it. Annex A refers to ADSL over POTS and Annex B refers to ADSL over ISDN.
The mode parameter specifies the standard that this port is allowed. When set to auto, the ALC1024 follows
whatever mode is set on the other end of the line.
When the mode is set to
auto and the negotiated mode is glite, the actual rates are governed
by G.lite, regardless of the configured numbers.
An example is shown next.
192.168.1.1 adsl> set port 4 debug auto
This command sets ADSL port 4 to have the debug profile. The results of this command are reflected when you
use the list profiles command.
7.5.18 Set Ports Command
Syntax:
192.168.1.1 adsl> set ports <profile name> <oper mode>
where
<profile name> =
The profile that will define the settings of this port.
<oper mode>
=
Operational mode. Choose from glite, gdmt, t1413 or auto for
Annex A. Choose from anxb or auto for Annex B.
The
set ports command assigns a specific profile to all of the ADSL ports and sets all of the ports to one mode,
or standard. The profile defines the maximum and minimum upstream/downstream rates, the target
upstream/downstream signal noise margins, and the maximum and minimum upstream/downstream acceptable
noise margins of all the ADSL ports.
The operational mode parameter specifies the standard that this port uses. When set to
auto, the ALC1024
follows whatever mode is set on the other end of the line.
When the mode is set to
auto and the negotiated mode is glite, the actual rates are governed
by G.lite, regardless of the configured numbers.
7.5.19 Show Port Command
Syntax:
show port <port number>
where
<port number>
= A port number, from 1 to 24.
To Next Page
Loading...
