ZyXEL Communications IES-2000 - Figure 20-3 Menu 6.2 - Ethernet Port Setup; Table 20-2 Menu 6.2 - Ethernet Port Setup

IES-2000/3000 User’s Guide
Port Setup 20-3
20.2.2 Ethernet Port Setup
Ethernet port connections can be half duplex or full duplex. The Ethernet port must use the same speed / duplex
mode setting as the peer Ethernet port in order to connect.
Please refer to Table 19-2 Menu 2 – Switch Setup for information on Ethernet port settings and section 19.2.3 for
information on port trunking.
Select an Ethernet port and then press [ENTER] to go to the Ethernet port setup menu.
Figure 20-3
Menu 6.2 – Ethernet Port Setup
The Menu 6.2
– VDSL Port Setup fields are explained in the next table.
Table 20-2 Menu 6.2 – Ethernet Port Setup
FIELD DESCRIPTION EXAMPLE
User Name Choose a descriptive name for identification purposes. This name can be
up to 30 alphanumeric characters long. Spaces are not allowed, but
dashes “-” and underscores "_" are accepted.
Uplink1
Active Press [SPACE BAR] to select Yes or No and press [ENTER] to enable or
disable the specified Ethernet port.
Yes
Type This read-only (r.o.) field displays the type of port you are currently
configuring. (Ethernet ports 13 & 14 relate to the VLC1012 only).
Ethernet
Speed Set Ethernet transmission speed (10 or 100 Mbps) in this field. The
VLC1012 automatically finds the speed of the attached device if you select
Auto; otherwise check the settings of the device attached to this port and
configure the same settings here. Press [SPACE BAR] to select from
Auto, 100M or 10M and then press [ENTER].
Auto
Duplex Set Ethernet duplex mode (full-duplex or half-duplex) in this field. The
VLC1012 automatically finds the mode of the attached device if you select
Auto in the Speed field; otherwise check the settings of the device
attached to this port and configure the same settings here. Press [SPACE
BAR] to select from Full or Half and then press [ENTER].
Full
Flow Control Enable or disable flow control on the Ethernet port in this field. Press
[SPACE BAR] and then [ENTER] to select either Yes or No.
Yes
Menu 6.2 – Ethernet Port Setup
User Name = Uplink1
Active = Yes
Type = ETHERNET (r.o)
Speed = Auto
Duplex = N/A
Flow Control = Yes
Edit Spanning Tree Protocol Setup= No
Edit VLAN Setup= No
Default Port Priority= 0
Press Enter to Confirm or ESC to Cancel: