ZyXEL Communications IES-2000 - Figure 28-4 Default VLAN Settings; Table 28-4 VLAN Key

IES-2000/3000 User’s Guide
28-8 Switch-Related Commands
Figure 28-4 Default VLAN Settings
In this example, port 0 is the CPU port, ports 1 to 12 are the VDSL ports and ports 13 and 14 are the Ethernet
ports. The numbers in the top row denote the outgoing port for the corresponding port listed on the left (its egress
port).
This example details the VLAN settings for the VLC1012.
Table 28-4 VLAN Key
SYMBOL DESCRIPTION
- A hyphen denotes that this port is not a member of the associated VLAN group.
0 A zero denotes the port itself.
X An “X” indicates a port’s egress (outgoing port).
To allow two subscriber ports to talk to each other, you must define the egress for both ports.
28.4.3 VLAN Set Command
Set Specific Egress Ports for a Port
Syntax:
sw vlan set n x1 x2
Use this command to set port(s) x1, x2, etc. to be the egress port(s) for port n. For example:
sw vlan set 1 3 4
Sets ports 3 and 4 to be the egress ports for port 1.
This is shown in the next figure.
VLAN map:
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
Port 0: O — — — — — — — — — — — — X X
Port 1: - O — — — — — — — — — — — X X
Port 2: - — O — — — — — — — — — — X X
Port 3: - — — O — — — — — — — — — X X
Port 4: - — — — O — — — — — — — — X X
Port 5: - — — — — O — — — — — — — X X
Port 6: - — — — — — O — — — — — — X X
Port 7: - — — — — — — O — — — — — X X
Port 8: - — — — — — — — O — — — — X X
Port 9: - — — — — — — — — O — — — X X
Port10: - — — — — — — — — — O — — X X
Port11: - — — — — — — — — — — O — X X
Port12: - — — — — — — — — — — — O X X
Port13: X X X X X X X X X X X X X O X
Port14: X X X X X X X X X X X X X X 0
Where 'O' means the port itself, 'X' means it’s VLAN member, and '-' is not
VLAN member.
vlc1012>
Egress port
Port numbers