IES-2000/3000 User’s Guide
21-2 Static Route Setup
Table 21-1 Edit IP Static Route Menu Fields
FIELD DESCRIPTION EXAMPLE
Active This field allows you to activate/deactivate this static route.
Yes
Destination IP
Address
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
IP Subnet Mask Enter the subnet mask for this destination. Follow the discussion on IP
subnet mask in this chapter.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your VLC1012 that forwards the packet to the destination.
The gateway must be a router on the same segment as your VLC1012.
Metric The metric represents the “cost” of transmission for routing purposes. IP
routing uses hop count as the measurement of cost, with a minimum of
1 for directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
1 to 15
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your
configuration, or press [ESC] at any time to cancel.
To Next Page
Loading...
