IES-2000/3000 User’s Guide
10-8 Bridge Commands
Port 12 (dsl11): 1
Port 13 (dsl12): 1
Port 14 (dsl13): 1
Port 15 (dsl14): 1
Port 16 (dsl15): 1
Port 17 (dsl16): 1
Port 18 (dsl17): 1
Port 19 (dsl18): 1
Port 20 (dsl19): 1
Port 21 (dsl20): 1
Port 22 (dsl21): 1
Port 23 (dsl22): 1
Port 24 (dsl23): 1
Port 25 (dsl24): 1
The above shows the current configuration of the port-based VLAN. It is the same as the default settings.
An example with an altered configuration is shown next.
192.168.1.1 > bridge
192.168.1.1 bridge> portfilter 2 1 3
192.168.1.1 bridge> portfilter 3 1 2
This example sets the allowed outgoing bridge ports of port 2 (DSL port 1) to port 1 (Ethernet uplink port) and
port 3 (DSL port 2). The allowed outgoing bridge ports of port 3 (DSL port 2) are set to port 1 (Ethernet
uplink port) and port 2 (DSL port1). This way, DSL ports 2 and 3 can communicate with each other and the
Ethernet uplink port. You can see the effects of this example by using the following command:
192.168.1.1 bridge> portfilter
Port 1 (ethernet): all
Port 2 (dsl1): 1 3
Port 3 (dsl2): 1 2
Port 4 (dsl3): 1
Port 5 (dsl4): 1
Port 6 (dsl5): 1
Port 7 (dsl6): 1
Port 8 (dsl7): 1
Port 9 (dsl8): 1
Port 10 (dsl9): 1
Port 11 (dsl10): 1
Port 12 (dsl11): 1
Port 13 (dsl12): 1
Port 14 (dsl13): 1
Port 15 (dsl14): 1
To Next Page
Loading...
