IES-2000/3000 User’s Guide
12-2 IEEE 802.1p Priority Commands
<regened priority> =
The regenerated user priority the incoming user priority is mapped
to for <port #>. Valid parameter range = [0 - 7], where 0 is the
lowest priority and 7 is the highest priority.
This command changes the priority of a tagged frame from a specified ingress port from the original user
priority to the regened priority.
To display the regeneration table, simply use the Regen Port command without parameters, as shown next.
192.168.1.1 vlan1q> regen port
To Next Page
Loading...
