IES-2000/3000 User’s Guide
Hardware Overview 3-17
Step 6. Connect the telephone wiring from the end-user’s DSL equipment to the lower ports of MDF 2.
Step 7. Connect the Telco-50 connector end of the cable you want for phone service to the Telco-50 connector
labeled CO on the splitter chassis rear panel.
Step 8. Connect the wiring on the other side of the Telco-50 cable to the lower ports of MDF 4 using a punch-
down tool.
Step 9. Connect the top ports of MDF 4 to the bottom ports of MDF 1 using regular telephone wires.
Step 10. Connect the top ports of MDF 1 to the telephone company.
3.4.4 POWER
Connect the ends of the –48VDC power cords to the power terminal blocks on the rear panel of your IES-3000.
Connect the other end of the cord(s) to an appropriate -48VDC power supply.
Make sure you are using the correct power source (see section 2.2 and 2.3 for more power
connection details).
To Next Page
Loading...
