Chapter 7 Interfaces
USG FLEX H Series User’s Guide
134
7.7.2 Configuring the System Default Trunk
Go to Network > Interface > Trunk > Default Trunk, select the default trunk entry and click Edit to open
the following screen. Use this screen to change the load balancing algorithm and view the bandwidth
allocations for each member interface.
Note: The new session is allocated to each member interface equally and is not allowed to
be changed for the default trunk.
Figure 98 Network > Interface > Trunk > Default Trunk > Edit
Mode Click this table cell and select Active to have the Zyxel Device always attempt to use this
connection.
Select Passive to have the Zyxel Device only use this connection when all of the
connections set to active are down. You can only set one of a group’s interfaces to passive
mode.
Parameter This field displays with the weighted round robin load balancing algorithm. Specify the
weight (1~10) for the interface. The weights of the different member interfaces form a ratio.
This ratio determines how much traffic the Zyxel Device assigns to each member interface.
The higher an interface’s weight is (relative to the weights of the interfaces), the more
sessions that interface should handle.
Apply Click this button to save your changes to the Zyxel Device.
Reset Click this button to return the screen to its last-saved settings.
Table 70 Configuration > Network > Interface > Trunk > Add (or Edit) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
