Chapter 8 Routing
USG FLEX H Series User’s Guide
145
Figure 103 Network > Routing > Static Route
The following table describes the labels in this screen.
8.3.1 Static Route Add/Edit Screen
Click Network > Routing > Static Route > Add/Edit to display the next screen. Use this screen to configure
the required information for a static route.
Table 76 Network > Routing > Static Route
LABEL DESCRIPTION
Add Click this to create a new static route.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to
remove it before doing so.
Name This is the name of the static route entry.
Destination This is the destination IP address.
Next-Hop This is the IP address of the next-hop gateway or the interface through which the traffic is
routed. The gateway is a router or switch on the same segment as your Zyxel Device's
interface(s). The gateway helps forward packets to their destinations.
Metric This is the route’s priority among the Zyxel Device’s routes. The smaller the number, the
higher priority the route has.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
