ZyXEL Communications USG FLEX H Series - IP Reputation Block List Screen

Chapter 17 Reputation Filter
USG FLEX H Series User’s Guide
277
17.2.2 IP Reputation Block List Screen
Use this screen to create block list entries. The Zyxel Device will block packets coming from the Internet
and going out from the local network that match the listed IPv4 addresses.
Click Security Service > Reputation Filter > IP Reputation > Block List to display the configuration screen
as shown next.
Figure 174 Security Service > Reputation Filter > IP Reputation > Block List
The following table describes the labels in this screen.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 138 Configuration > Security Service > Reputation Filter > IP Reputation > Allow List (continued)
LABEL DESCRIPTION
Table 139 Configuration > Security Service > Reputation Filter > IP Reputation > Block List
LABEL DESCRIPTION
Enable Select this to bypass checking by this feature (if enabled) and automatically block:
• incoming packets coming from the listed IPv4 addresses.
• outgoing packets going to the listed IPv4 addresses.
Log Select log if you want the Zyxel Device to create a log recording when there are
incoming or outgoing packets that come from or go to the listed IPv4 addresses.
Select no if you don’t want the Zyxel Device to create a log.
Add Click this to create a new entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
Active To turn on an entry, select it and click Active.
Inactive To turn off an entry, select it and click Inactive.