USG FLEX H Series User’s Guide
43
CHAPTER 3
Hardware, Interfaces and
Zones
3.1 Hardware Overview
This section describes the front and rear panels for each model.
The following table summarizes the port features of the Zyxel Device by model.
For information on interface names by model, default port or interface name mapping, and default
interface or zone mapping please see
Section 3.4 on page 56.
3.1.1 Multi-Gigabit
Multi-Gigabit Ethernet ports automatically allow connections up to the speed of the connected network
device (100M, 1G, 2.5G, 5G, or 10G), and you just need to use a CAT 5e or CAT 6 Ethernet cable. You
must use CAT 6A or better Ethernet cables to achieve 10G speeds.
See the following table for the cables required and distance limitation to attain the corresponding
speed.
Table 12 USG FLEX Series Port Comparison Table
USG FLEX MODELS
USG FLEX
100H
USG FLEX
100HP
USG FLEX
200H
USG FLEX
200HP
USG FLEX
500H
USG FLEX
700H
USB 3.0 Ports 1 1 1 1 1 1
10 Gbps SFP+ interface - - - - - 2
PoE+ Port - 1 - 1 2 2
10/100/1000 Mbps Ethernet
Ports
8 8 6 6 8 8
Multi-Gigabit Ethernet Ports - - 2 2 4 4
Console Port 1 (RJ45) 1 (RJ45) 1 (RJ45) 1 (RJ45) 1 (RJ45) 1 (RJ45)
Table 13 Cable Types
CABLE TRANSMISSION SPEED MAXIMUM DISTANCE BANDWIDTH CAPACITY
Category 5 100M 100 m 100 MHz
Category 5e 1G 100 m 100 MHz
Category 6
1G / 10G
100m:1G
37-50m:10G
250 MHz
Category 6a 10G 100 m 500 MHz
Category 7 10G 100 m 600 MHz
To Next Page
Loading...
