ZyXEL Communications USG FLEX H Series - Alert

Chapter 24 System
USG FLEX H Series User’s Guide
377
24.5.2 Alert
Use this screen to configure where to email the alerts when they’re generated. Alerts are used for events
that require more serious attention, such as system errors and attacks.
Click System > Notification > Alert to display the following screen.
Figure 231 System > Notification > Alert
The following table describes the labels in this screen.
Password This box is effective when you select the SMTP Authentication check box. Type a password to
provide to the SMTP server when the log is emailed. Use 4 to 63 characters, including 0-9a-zA-
Z‘~!@#$%^&*()_+={}|\;:”<>’./
Retype to
Confirm
Type the password again to make sure that you have entered is correctly.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 187 System > Notification > Mail Server (continued)
LABEL DESCRIPTION
Table 188 System > Notification > Alert
LABEL DESCRIPTION
Active Enable this to send log messages and alert to the email address you specify below.
Mail Subject Type the subject line for the outgoing email
Send From Type the email address from which the outgoing email is delivered. This address is used in
replies.
Send Alerts to Type the email address to which alerts are delivered.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.