Chapter 8 Routing
USG FLEX H Series User’s Guide
144
8.3 Static Route Screen
Click Network > Routing > Static Route to open the Static Route screen. This screen displays the
configured static routes.
DSCP Marking Set how the Zyxel Device handles the DSCP value of the outgoing packets that match this
route.
Select one of the pre-defined DSCP values to apply or select User Define to specify another
DSCP value. The “af” choices stand for Assured Forwarding. The number following the “af”
identifies one of four classes and one of three drop preferences. See
Assured Forwarding
(AF) PHB for DiffServ for more details.
Select preserve to have the Zyxel Device keep the packets’ original DSCP value.
Select default to have the Zyxel Device set the DSCP value of the packets to 0.
User-Defined
DSCP Marking
Use this field to specify a custom DSCP value.
Address Translation Use this section to configure NAT for the policy route. This section does not apply to policy
routes that use a VPN tunnel as the next hop.
Source Network
Address Translation
Select none to not use NAT for the route.
Select outgoing-interface to use the IP address of the outgoing interface as the source IP
address of the packets that matches this route.
To use SNAT for a virtual interface that is in the same WAN trunk as the physical interface to
which the virtual interface is bound, the virtual interface and physical interface must be in
different subnets.
Otherwise, select a pre-defined address (group) to use as the source IP address(es) of the
packets that match this route.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 75 Network > Routing > Policy Route > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
