Chapter 5 Monitor
USG FLEX H Series User’s Guide
88
5.17 The IPSec VPN Screen
Click a column’s heading cell to sort the table entries by that column’s criteria. Click the heading cell
again to reverse the sort order.
5.17.1 The Site to Site VPN Screen
Use this screen to display and to manage active IPSec SAs.
To access this screen, click VPN Status > IPSec VPN > Site to Site VPN. The following screen appears.
Figure 74 VPN Status > IPSec VPN > Site to Site VPN
Each field is described in the following table.
Release Select an entry and click on this button to let other devices use the dynamic DHCP that is
currently assigned to the selected entry.
Unreserve Select an entry and click on this button to set the entry from a static DHCP entry to a
dynamic DHCP entry. The IP address is assigned to a DHCP client.
Refresh Click this button to update the mapping between IP addresses and MAC addresses.
Interface This field identifies the interface that assigned an IP address to a DHCP client.
IP Address This field displays the IP address currently assigned to a DHCP client or reserved for a
specific MAC address. Click the column’s heading cell to sort the table entries by IP
address. Click the heading cell again to reverse the sort order.
Host Name This field displays the name used to identify this device on the network (the computer
name). The Zyxel Device learns these from the DHCP client requests. “None” shows here
for a static DHCP entry.
MAC Address This field displays the MAC address to which the IP address is currently assigned or for
which the IP address is reserved. Click the column’s heading cell to sort the table entries
by MAC address. Click the heading cell again to reverse the sort order.
Expire Time This displays the date and time the DHCP-assigned address will be renewed.
Table 47 Network Status > DHCP Table (continued)
LABEL DESCRIPTION
Table 48 VPN Status > IPSec VPN > Site to Site VPN
LABEL DESCRIPTION
Disconnect Select an IPSec SA and click this button to disconnect it.
Refresh Select an IPSec SA and click this button to update its status.
# This field is a sequential value, and it is not associated with a specific SA.
To Next Page
Loading...
