ZyXEL Communications USG FLEX H Series - 3.3 Power Cord Lock

Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User’s Guide
53
Figure 46 Wall Mounting
Note: Wall-mount the Zyxel Device horizontally. The Zyxel Device's side panels with ventilation
slots should not be facing up or down as this position is less safe.
Make sure there is 100 mm of clearance at the sides and 1 – 1.5 mm distance between
the screw head and the wall to allow air circulation and the attachment of cables and
the power cord.
3.3 Power Cord Lock
Follow the steps below to use the power cord lock to secure the power cord connected to the Zyxel
Device.
3.3.1 For USG FLEX 100H, USG FLEX 100HP, USG FLEX 200H, USG FLEX 200HP,
USG FLEX 500H
1 Use a screw driver to remove the power cord lock and the screw from the Zyxel Device.