ZyXEL Communications USG FLEX H Series - The Zone Screen

Chapter 14 Object
USG FLEX H Series User’s Guide
224
14.3.2 The Zone Screen
The Zone screen provides a summary of all zones. In addition, this screen allows you to add, edit, and
remove zones. To access this screen, click Object > Zone.
Figure 154 Object > Zone
The following table describes the labels in this screen.
14.3.2.1 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go to the Zone screen (see
Section 14.4.2 on page 226), and click the Add icon or an Edit icon.
Table 115 Object > Zone
LABEL DESCRIPTION
User Configuration The Zyxel Device comes with pre-configured system default zones that you cannot
delete. You can create your own zones by clicking Add.
Add Click this to create a new, user-configured zone.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove a user-configured trunk, select it and click Remove. The Zyxel Device
confirms you want to remove it before doing so.
Reference Select an entry and click Reference to check which settings use the entry.
Name This field displays the name of the zone.
Members This field displays the names of the interfaces that belong to each zone.
Description This field displays the description of the zone.
Reference This field displays the number of times an Object Reference is used in a policy.