ZyXEL Communications USG FLEX H Series - The Remote Access VPN Screen

Chapter 5 Monitor
USG FLEX H Series User’s Guide
89
5.17.2 The Remote Access VPN Screen
Use this screen to display or disconnect remote access VPN clients that are connected to the Zyxel
Device. The remote access VPN clients must have SecuExtender or use supported computer or mobile
operating systems; see
Section 11.4 on page 178 for more information.
To access this screen, click VPN Status > IPSec VPN > Remote Access VPN. The following screen appears.
Figure 75 VPN Status > IPSec VPN > Remote Access VPN
Each field is described in the following table.
Name This field only displays the client names if they’re using EAP or X-auth for
authentication.
If a client is connected to the Zyxel Device without using Extended Authentication
Protocol (EAP) or X-Auth, this field will be empty.
Policy Route This field displays the content of the local and remote policies for this IPSec SA. The IP
addresses, not the address objects, are displayed.
My Address This field displays the IP address of the Zyxel Device.
Remote Gateway This field displays the IP address of the remote gateway.
Uptime This field displays how many seconds the IPSec SA has been active. This field displays
N/A if the IPSec SA uses manual keys.
Rekey This field displays how many seconds remain in the SA life time, before the Zyxel
Device automatically disconnects the IPSec SA. This field displays N/A if the IPSec SA
uses manual keys.
Inbound (Bytes) This field displays the amount of traffic that has gone through the IPSec SA from the
remote IPSec router to the Zyxel Device since the IPSec SA was established.
Outbound (Bytes) This field displays the amount of traffic that has gone through the IPSec SA from the
Zyxel Device to the remote IPSec router since the IPSec SA was established.
Table 48 VPN Status > IPSec (continued)VPN > Site to Site VPN
LABEL DESCRIPTION
Table 49 VPN Status > IPSec VPN > Remote Access VPN
LABEL DESCRIPTION
Disconnect Select a remote access VPN client and click this button to disconnect it.
Refresh Click Refresh to update this screen.
# This field is a sequential value, and it is not associated with a specific remote access
VPN client.
Username This field displays the name of the remote access VPN client.
Assigned IP This field displays the IP address the user used to establish this remote access VPN
connection.
Remote IP This field displays the IP address of the remote IPSec router the remote access VPN
client is connected to.