Chapter 21 IP Exception
USG FLEX H Series User’s Guide
316
21.2.1 The IP Exception Add/Edit Screen
Use this screen to add or edit entries of IPv4 address in the IP exception list.
Click Security Service > IP Exception > Add/Edit to display the following screen.
Figure 196 Security Service > IP Exception > Add/Edit
The following table describes the fields in this screen.
Table 158 Security Service > IP Exception > Add/Edit
LABEL DESCRIPTION
Name Enter a descriptive name of this entry. You may use 2-31 alphanumeric characters,
underscores (_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Source Select any or an address object of the source IP address for this entry. Select any so there’s no
restriction on the source IP address.
Destination Select any or an address object of the destination IP address for this entry. Select any so
there’s no restriction on the destination IP address.
Log The Zyxel Device does not inspect packets with the selected service if you select Yes. The
Zyxel Device will also generate a log when the incoming traffic is in th exception list.
Otherwise, select No.
Service to Bypass Selected services do not inspect packets that match source/destination criteria above. Non-
selected services do inspect packets that match source/destination criteria above.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
