ZyXEL Communications USG FLEX H Series - Policy Route Edit Screen

Chapter 8 Routing
USG FLEX H Series User’s Guide
141
8.2.1 Policy Route Edit Screen
Click Network > Routing to open the Policy Route screen. Then click the Add or Edit icon. The Add Policy
Route or Policy Route Edit screen opens. Use this screen to configure or edit a policy route.
DSCP Marking This is how the Zyxel Device handles the DSCP value of the outgoing packets that match
this route. If this field displays a DSCP value, the Zyxel Device applies that DSCP value to
the route’s outgoing packets.
preserve means the Zyxel Device does not modify the DSCP value of the route’s outgoing
packets.
default means the Zyxel Device sets the DSCP value of the route’s outgoing packets to 0.
The “af” choices stand for Assured Forwarding. The number following the “af” identifies
one of four classes and one of three drop preferences. See
Assured Forwarding (AF) PHB
for DiffServ for more details.
SNAT This is the source IP address that the route uses.
It displays none if the Zyxel Device does not perform NAT for this route.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 74 Network > Routing > Policy Route (continued)
LABEL DESCRIPTION