Chapter 17 Reputation Filter
USG FLEX H Series User’s Guide
276
17.2.1 IP Reputation Allow List Screen
Use this screen to create allow list entries. The Zyxel Device will allow packets coming from the Internet
and going out from the local network that match the listed IPv4 addresses.
Click Security Service > Reputation Filter > IP Reputation > Allow List to display the configuration screen
as shown next.
Figure 173 Security Service > Reputation Filter > IP Reputation > Allow List
The following table describes the labels in this screen.
Table 138 Configuration > Security Service > Reputation Filter > IP Reputation > Allow List
LABEL DESCRIPTION
Enable Select this to bypass checking by this feature (if enabled) and automatically allow:
• incoming packets that come from the listed IPv4 addresses.
• outgoing packets that go to the listed IPv4 addresses.
Log Select log if you want the Zyxel Device to create a log recording when there are
incoming or outgoing packets that come from or go to the listed IPv4 addresses.
Select no if you don’t want the Zyxel Device to create a log.
Add Click this to create a new entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
Active To turn on an entry, select it and click Active.
Inactive To turn off an entry, select it and click Inactive.
Enable/Disable To turn on an entry, select it and click Enable.
To turn off an entry, select it and click Disable.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
IPv4 Address This field displays the IPv4 address of this entry.
To Next Page
Loading...
